Somfy Altus 50 Rts Manual

'Motor with integrated radio control. A classic multi-purpose unit to motorise a host of products (roller shutters, awnings, vertical blinds, etc.) Up, down and stop functions, and can be pre-programmed with 'my' favourite position.

.Altus RTS Motor (Quick Reference Guide) (Modification programming) Change the Direction Connect AC to one motor at a time. You must reset an already programmed motor before you can change the direction (see below).

Once reset, press and hold the Up and Down buttons simultaneously until the motor jogs, then release. Press the Stop button for more than 5 seconds until the motor jogs, then release.Altus RTS Motor (Quick Reference Guide) (Initial programming) Initiate Programming Connect AC to one motor at a time. Select the transmitter/channel you want to use. Press and hold both the Up and Down buttons simultaneously until the motor jogs, then release. (A jog is a short up and down movement of the motor) Check/Change the Direction Check the direction of operation (the motor will operate in momentary fashion).

CABLE OUTPUT AXIAL OUTPUT: Pass the supply cable through the center hole of the yellow motor head cover. 5) RADIAL OUTPUT: Pass the supply cable through. Recommends using a Tester Cable (T.C.) Cat. 6020086 to set the motor limits, and to ensure the system is operating correctly before the final electrical connection is. Coconut grinder. Cable switch is in the center 'OFF' position, and connect T.C. To motor leads by matching color codes.

Remove the protective cap covering the limit setting buttons. Always remember to affix the protective cap over the limit switch buttons. NOTE: Tubular motors are not continuously rated. They have a built-in thermal overload device which limits. Not act as a direct conduit for the water to enter the head of the motor (form drip loops).AWNING HOOD6.

WIRING/INSTALLATION RECOMMENDATIONS120VAC 60Hz A. Weather elements such as rain, sleet.etc. SOMFY reserves the right to void the motor warranty if the wiring recommendations are not followed. TROUBLESHOOTING GUIDESYSTEM DOES NOT. Use of 409R2.

LT50 Based on use of 510R2Special Application MotorsILT MotorThe ILT motor features an on board microprocessor and uses a digital shaft encoder to. Tube.AFABRIC MOTOR STRAP MOTOR STRAP MOTORBFABRIC MOTOR FABRIC MOTORCSTRAP MOTOR STRAP MOTORDFABRIC MOTORMOTOR HEADSMOTOR HEADSSTRAP MOTORFABRIC MOTORFABRIC MOTORSTRAP MOTORSTRAP MOTORFABRIC MOTORFABRIC MOTORSTRAP MOTORWIRINGWhite Black Red. #. Common Winding Tension Brake GroundFABRIC MOTORFABRIC MOTORFABRIC MOTORFABRIC MOTORSTRAP MOTORWhite Red Black Gray Green.

USE GROUND BARSTRAP MOTORWhite Black Red Gray Green. USE GROUND. The limit switch adjustment button by pressing it down again.Motor on LeftMotor on RightPosition 2Motor on LeftMotor on RightAdjustment of Upper and Lower Positions for the. For operation of the ILT switch, please refer to ILT switch Instructions.SLT MotorSLT Motor- The SLT motor comes in two versions: Left Mount (blue and yellow buttons), and Right.

WNINGSSomfy Altus Motor Wiring DiagramLT50 ALTUS RTSGROUNDNEUTRALLINEPowerLT50 RTS CMOGROUNDNEUTRALLINEPowerNote: Only RTS and ILT motors can be wired in parallel.LT50 ALTUS RTS AND LT50 RTS CMO MOTOR WIRING COLOR CODE 120V AC BLACK WHITE GREEN CODE (H) HOT (N) NEUTRAL (G) GROUND1600 E. Gertrude Pl., Santa Ana, CA 92705 Ph: 800-332-2866, Fax: 714-708-1399, License # 700678 info@accentawnings.comSanta Ana8132 Miramar Rd., San Diego, CA 92126 Ph: 858-621-6300, Fax: 858-621-6333, License # 700678 info@accentawnings.comSan Diego.